Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16635 Discussions

Signal tap not working in Quartus Pro 18.0

ASvir2
Beginner
‎12-21-2018 11:30 AM
1,275 Views

Hi all!

 

I'm working on a design for a custom board with Cyclone 10 GX FPGA.

I am able to program the design using jtag, but I'm unable to use Signal Tap (there's "instance not found" message under status).

I downloaded .sof for sure because I see leds toggling, in fitter report signal tap uses some resources and it's enabled in project settings.

 

Did anyone else have this issue?

 

I'm using Quartus Pro 18.0.

 

Thank you.

0 Kudos

Link Copied

1 Reply
ASvir2
Beginner
‎12-21-2018 04:07 PM
397 Views

Just a quick update, I managed to solve my problem by changing the jtag clock frequency on usb blaster II from 24 MHz to 6MHz.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.