- Marquer comme nouveau
- Marquer
- S'abonner
- Sourdine
- S'abonner au fil RSS
- Surligner
- Imprimer
- Signaler un contenu inapproprié
Greetings everyone
I have created a project using block diagram schematic in quartus ii software. The project is a simple multiplexing system. I have downloaded the project into the target FPGA on Altera DE2 board. The project runs without problem and the LEDs show the blinking correctly. But I just can't Simulate the project using Quartus II waveform editor. So, what is the reason for that???? I mean if the project runs correctly that means there is no problem, so why not giving output in Simulation??? Thanks!- Balises:
- Intel® Quartus® Prime Software
Lien copié
1 Répondre
- Marquer comme nouveau
- Marquer
- S'abonner
- Sourdine
- S'abonner au fil RSS
- Surligner
- Imprimer
- Signaler un contenu inapproprié
Have your created a test bench to drive the inputs?

Répondre
Options du sujet
- S'abonner au fil RSS
- Marquer le sujet comme nouveau
- Marquer le sujet comme lu
- Placer ce Sujet en tête de liste pour l'utilisateur actuel
- Marquer
- S'abonner
- Page imprimable