- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Can anybody help me regarding to simulation time seetings.. For example..I am using clocked input so that by increase the simulation time all the inputs can be entered... I m Using Quartus II 7.2 Web edition. regards HasanLink Copied
5 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is probably not going to help much, I think you need to be more clear. Do you mean you want to have a serial input, so that each cycle one portion of the input data is entered?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi..
yes.. I have taken few input as clocked input.. So I want do some process using that input... Therefore, can anybody help me how I can increase the simulation time so that i can take more clocked (synchronize) input..and process that input and finally I can show that output within the simulation time.. thank you for your help- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You mean the simulation time setting in waveform editor?. It's Edit menu: End Time.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi....
Yes how can I setting the wave form for increase the simulatuion time..?? So that I can process the input and show the output within the simulation time- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can either set the end time, or advance the time as you want using the "run" command.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page