Unwanted SignalTap trigger time out

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

Unwanted SignalTap trigger time out

889 Views

I have set up a trigger condition in SignalTap that should take some time until it occurs. But I seem to get a time out after a few seconds without any feedback, it will just stop acquiring data and there is no values in the data window.

Is there a way to set the time out?

I have run similar things on a different computer and it waited forever until the trigger condition was met.

Running remote with SignalTap v 10.1sp1 as server and v11 as client.

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.