Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

change pin assignment after synthesis

Altera_Forum
Honored Contributor II
‎11-17-2016 11:49 AM
1,258 Views

hello, 

I would like to change pin assignment after synthesis, meaning no need to synthsise the design. 

is it poosible at all? 

and if it is- how? 

Thanks  

Yotam
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎11-17-2016 05:00 PM
535 Views

Pin assignments wont take affect until the fitter stage. So you should be able to change the pin assignments and then only run the fit/assembler.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.