Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

compile and simulate 2 schematics in single project

Altera_Forum
Honored Contributor II
‎11-06-2009 08:04 AM
970 Views

Hi all, 

 

how to compile, simulate two schematics in a single project. Capturing whole lot of ckts in single schma is not possible, we are breaking into modules. So that at the end of the day each module captured in diff schematics under same project can be compiled and simulated. 

 

i could add but the signal referencing was not taking place from one page to another. 

 

Any help would be greatly appreciated
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.