make: Leaving directory '/usr/src/linux-headers-5.4.0-1031-azure' Cannot find JTAG cable.

[NSVR]

Hi 

I am trying to setup FPGA , I am able to install quartus prime software with devices and in next step  I am following the below link where we were asked to run fpga_install.sh but  when I am running the same I am getting this error.

make: Leaving directory '/usr/src/linux-headers-5.4.0-1031-azure' Cannot find JTAG cable. Aborting installation

https://docs.openvinotoolkit.org/2020.3/_docs_install_guides_VisionAcceleratorFPGA_Configure.html

[AnilErinch_A_Intel]

Hi ,

Please let us know that whether a jtag or usb-jtag cable has been properly to the board,

You can use the below link as a reference

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/embedded/2018/why-do-i-get-the-error-no-jtag-hardware-available-when-running-j.html

Please let us know the feedback.

Thanks and Regards

Anil

[NSVR]

Hi,

I am doing setup in Azure vm. so there is no scope to check "whether a jtag or usb-jtag cable has been properly to the board" or we should assume that was plugged properly.

I have tried you link as well. but no use

[AnilErinch_A_Intel]

Hi ,

Please let us know the results obtained after running the jtagconfig,

You may also have to explore on how the devices work in the Azure VM.

Thanks and Regards

Anil