Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

use OpenCL kit as a general FPGA development kit?

Altera_Forum
Honored Contributor II
‎09-08-2015 07:03 PM
1,014 Views

Hi, 

 

Is it possible to use one Nallatech OpenCL Board as one general FPGA kit? For example, using it to run application examples provided by Altera. And after that, restore the board as its original OpenCL accelerator? 

If so, what should I pay attention to when I assign all the pin locations in my custom example, and program the FPGA? Can I use partial reconfiguration on it? 

 

Thanks.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.