Archer City can't display BIOS interface， but it can display os interface.

[Arthur78]

Hi ，

     at the beginning  ,i'm running Archer City normally，everything is ok, I can see the BIOS interface by clik  deltete key.

      i don't know  if i changed something,  it can't show the BIOS interface anymore. 

      but OS can start normally.

     I found there is a err log at the bios stage  which did not exist earlier.

    you can see the err log through the  attachment .

   can you give me a hand?

Thanks

[Arthur78]

further more，i did work on the jumper.

short J5C4 to BIOS recover mode,  no change.

short J2A1 to clear CMOS, no change.

what's the problem behind it?

Thanks

[Fikri_Intel]

Hi Arthur78,

Thank you for contacting Intel.

We appreciate you reaching out to us regarding the reported issue.

To address your recent question, we highly recommend you contact our Field Application Engineer (FAE) for specialized assistance. Alternatively, you can open a new ticket through the Intel® Software Development Platform (Intel® SDP): http://www.intel.com/sdp for further support.

Thus, we will proceed to close this thread.

Regards,

Fikri O.