Intel® Xeon® Processor and Server Products
Intel® Xeon® Processors, Data Center Products including boards, integrated systems, and RAID Storage
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.

S5500BC Power control fault

RTimb
Beginner
3,178 Views

What should I do if the server board

S5500BC leave a beep code Power control fault 1-5-4-4. What should replace serverboard? I've tried with a new Power Supply but still gives the same error message.

0 Kudos
1 Solution
idata
Employee
2,100 Views

That specific beep code relates to power failures in you already replaced the power supply then the next course of action would be trying the board outside the chassis to discard any grounding issues.

 

 

If the issue persists then it would be the main power connector of the board that is defective. For this matter replacing the board would be the next course of action.

 

 

View solution in original post

0 Kudos
1 Reply
idata
Employee
2,101 Views

That specific beep code relates to power failures in you already replaced the power supply then the next course of action would be trying the board outside the chassis to discard any grounding issues.

 

 

If the issue persists then it would be the main power connector of the board that is defective. For this matter replacing the board would be the next course of action.

 

 

0 Kudos
Reply