Intel Manageability Forum for Intel® EMA, AMT, SCS & Manageability Commander
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
Success! Subscription added.
Success! Subscription removed.
Sorry, you must verify to complete this action. Please click the verification link in your email. You may re-send via your
profile.
I have an Intel software development platform(AMT 6.0 ,D3CB2 family) ,I have provisioned it once with one-touch manner, I want to know how to restore it to factory setting, because I want to test the zero-touch provisioning.
You will need to perform unprovisioning to get back to the factory state. Use the WS-Management AMT_SetupAndConfigurationService.Unprovision() method or the equivalent SOAP command. The SDK documentation talks about what gets reset when you perform these commands.
I am a tester and am not familiar with the coding,Are there other ways to restore the amt to the factory setting? Such as RTCRST jumper or other manual operator .
