Intel vPro® Platform
Intel Manageability Forum for Intel® EMA, AMT, SCS & Manageability Commander
2917 Discussions

how to restore AMT 6.0 to factory setting

idata
Employee
‎03-08-2011 03:05 AM
1,969 Views

I have an Intel software development platform(AMT 6.0 ,D3CB2 family) ,I have provisioned it once with one-touch manner, I want to know how to restore it to factory setting, because I want to test the zero-touch provisioning.

0 Kudos

Link Copied

3 Replies
idata
Employee
‎03-09-2011 06:18 AM
401 Views

You will need to perform unprovisioning to get back to the factory state. Use the WS-Management AMT_SetupAndConfigurationService.Unprovision() method or the equivalent SOAP command. The SDK documentation talks about what gets reset when you perform these commands.

Good luck!

0 Kudos
Copy link
idata
Employee
‎03-09-2011 07:30 PM
401 Views
In response to idata

I am a tester and am not familiar with the coding,Are there other ways to restore the amt to the factory setting? Such as RTCRST jumper or other manual operator .

In response to idata
0 Kudos
Copy link
MPala11
New Contributor II
‎02-16-2012 08:14 AM
401 Views
In response to idata

All Intel AMT settings can be returned to factory default by clearing the CMOS (via the jumper or CMOS battery)

Thanks,

Mani

In response to idata
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.