How to count fingers with hand tracking?

[idata]

I know there is an example of doing it on the SDK but that is just too complicated to understand.

So, I will really appreciate if somebody could write a simple example of counting the number of fingers in 2 hands (from 0 to 10 fingers).

EDIT:

My camera model is SR300 and I'm programming in C# .

Thanks in advance.

[idata]

Hello Oren,

We've just sent you an email regarding your service ticket 03065210. We recommend you to check your inbox (and your junk/spam folder) to check our message.

Best regards,

Josh B.

Intel Customer Support

[idata · Accepted solution]

Hello JustaR,

Thank you for contacted Intel® RealSense™ Technology support.Your case number is 03065210As we promised on our previous interaction, we did further investigate on your request, and we regret to inform you that there is not an official step by step guide or any simple example of counting the number of fingers in 2 hands (from 0 to 10 fingers) using the Intel® RealSense™ Technology.As a best effort in order to further assist you, we advise you to visit the following site:https://mtaulty.com/2015/04/23/m_15810/ https://mtaulty.com/2015/04/23/m_15810/I hope you find this information helpful. "Disclaimer:These links are being offered for your convenience and should not be viewed as an endorsement by Intel of the content, products, or services offered there." Best regards, Josh B.Intel Customer Support

[idata]

Thank you for your response,

Finally, I decided to make a comperation between the finger tips and the B joints,

this way I was able to determine in wich state the fingers are, and by that, couting the fingers (even tho that it wasn't so efficient).