- Marcar como novo
- Marcador
- Subscrever
- Silenciar
- Subscrever fonte RSS
- Destacar
- Imprimir
- Denunciar conteúdo inapropriado
i use altera cyclone board,the flash's capacity is 8M¡£my uclinux kernel is about 2099k, filesystem is about 1987k.
while i download the kernel, filesystem is covered. error:Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,0) download the filesystem,kernel is covered. sometimes the safe configuration is covered too(red led is on). the flash still worked well,but yesterday the problem happened. please tell me how to solve it,thank u!!!!Link copiado
3 Respostas
- Marcar como novo
- Marcador
- Subscrever
- Silenciar
- Subscrever fonte RSS
- Destacar
- Imprimir
- Denunciar conteúdo inapropriado
the information:
uClinux/Nios II Altera Nios II support © 2004 Microtronix Datacom Ltd. setup_arch: No persistant network settings signature at 007F0000 Built 1 zonelists Kernel command line: root=/dev/mtdblock0 ro PID hash table entries: 128 (order: 7, 2048 bytes) Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory available: 14384k/16384k RAM, 0k/0k ROM (1480k kernel code, 327k data) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) NET: Registered protocol family 16 NIOS serial driver version 0.0 ttyS0 (irq = 4) is a builtin NIOS UART Serial: JTAG UART driver $Revision: 1.3 $ ttyJ0 at MMIO 0x80920820 (irq = 1) is a jtag_uart RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize smc_probe: 50000 Khz Nios SMSC LAN91C111 Driver (v2.1), (Linux Kernel 2.6) eth0: SMC91C11xFD(rev:1) at 0x80910300 IRQ:6 MEMSIZE:8192b NOWAIT:0 ADDR: 00:07: ed:00:00:00 smc_probe: 50000 Khz Nios Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx CF: ctl=1 hda: Hitachi CV 7.1.1, CFA DISK drive Using anticipatory io scheduler ide0 at 0x80900800-0x80900807,0x80900838 on irq 8 hda: max request size: 128KiB hda: 31488 sectors (16 MB) w/1KiB Cache, CHS=246/4/32 hda:<6>check_part[0]=17230780: hda1 res=1:<4>CFI: Found no Microtronix map device at location zero JEDEC: Found no Microtronix map device at location zero NET: Registered protocol family 2 IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 1024 bind 2048) NET: Registered protocol family 1 NET: Registered protocol family 17 VFS: Cannot open root device "mtdblock0" or unknown-block(0,0) Please append a correct "root=" boot option Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0) ---------then stop,7-seg led is 88.- Marcar como novo
- Marcador
- Subscrever
- Silenciar
- Subscrever fonte RSS
- Destacar
- Imprimir
- Denunciar conteúdo inapropriado
If you can remove something you don't really need in kernel, and make the kernel smaller than 2M, that will be the best. If you can not reduce the size of kernel to less than 2M, I would recommend u-boot, which allows you to compress the kernel to less than 1M.
- Marcar como novo
- Marcador
- Subscrever
- Silenciar
- Subscrever fonte RSS
- Destacar
- Imprimir
- Denunciar conteúdo inapropriado
it's ok ! thank wentao very much!!!

Responder
Opções do tópico
- Subscrever fonte RSS
- Marcar tópico como novo
- Marcar tópico como lido
- Flutuar este Tópico para o utilizador atual
- Marcador
- Subscrever
- Página amigável para impressora