Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

Bonding driver support

Altera_Forum
Honored Contributor II
‎01-22-2010 06:10 PM
1,198 Views

Hi , 

 

I have selected "bonding driver support" 

make menuconfig 

device drivers -> network device support -> bonding driver support 

 

and then what should I do to make my board support bonding in nios2-uClinux. 

 

my board have two ethernet port : eth0 & eth1 

 

who can give me some advice? 

 

thank you !
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.