Dausing target processor: not responding.

[Altera_Forum]

--------------------- 

 Using cable "USB-Blaster [USB-0]", device 1, instance 0x00 Pausing target processor: not responding. Resetting and trying again: FAILED Leaving target processor paused  ----------------these are the error message when i want to run a project on the  target board in the nios2IDE.  Then use the SDK,i try to connect the target,command "nios2-terminal",the responding show that it can connect .   Then i use the command "nios2-gdb-server" ,the error message : ---------------------  Using cable "USB-Blaster [USB-0]", device 1, instance 0x00 Pausing target processor: not responding. Resetting and trying again: FAILED Leaving target processor paused  ----------------  then try the command "nios2-run ***" .it's message is "....... waiting for target .。。。。。。。。。。。。"　　then it no repond.  I think others may come up aganist this problem too.  How are you solve that finally?

[Altera_Forum]

I've been having this same problem too. I get the error message: 

 Using cable "ByteBlasterMV [LPT1]", device 1, instance 0x01 Pausing target processor: not responding. Resetting and trying again: FAILED Leaving target processor paused  I can program my .sof to the board no problem, I can compile my C application too, but when i go to run the C code on the processor I get that error message. I can't even use the flash programmmer to program the flash memory either, I get an error along the same lines as the one above.  If anybody has any ideas i'd greatly appreciate them.