Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

Eclipse 20.1 Fails to Program Nios unless Programmer Open in Quartus

James_B
New Contributor II
2,040 Views

I get the message "Unable to validate connection settings" in Eclipse 20.1 when attempting to program the Nios II processor on the DE10-Nano board when the FPGA section is already programmed. 

If I have the programmer open in Quartus, then Eclipse can download the program successfully. 

This doesn't make sense, can someone please explain? Is it that Eclipse 20.1 has to see a USB identifier or something that is enabled when the Quartus programming tool is open? 

Thanks. James

0 Kudos
1 Solution
James_B
New Contributor II
1,958 Views

Aik, 

Thanks for the feedback here. No, nothing more is required on this. The issue has been consistent. The solution has been to always open the JTAG programmer before opening Eclipse. 

Thanks, James

View solution in original post

0 Kudos
2 Replies
aikeu
Employee
1,965 Views

Hi James_B,


Sorry for late reply, do you still requires help on this?


Thanks.


Regards,

Aik Eu


0 Kudos
James_B
New Contributor II
1,959 Views

Aik, 

Thanks for the feedback here. No, nothing more is required on this. The issue has been consistent. The solution has been to always open the JTAG programmer before opening Eclipse. 

Thanks, James

0 Kudos
Reply