Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12627 Discussions

Error from the tutorial of Generating and Compiling Cyclone V Preloader

SONG
Beginner
2,458 Views

Hi, I have an Error from the tutorial of Generating and Compiling Cyclone V Preloader.

 

the error message is here

------------------

C:\intelFPGA\18.0\embedded\host_tools\mentor\gnu\arm\baremetal\bin\arm-altera-eabi-ld.exe: cannot open map file u-boot-spl.map: Permission denied

Makefile:178: '/cygdrive/c/intelFPGA/18.0/embedded/examples/hardware/cv_soc_devkit_ghrd/software/spl_bsp/uboot-socfpga/spl/u-boot-spl' 타겟에 대한 명령이 실패했습니다

make[2]: *** [/cygdrive/c/intelFPGA/18.0/embedded/examples/hardware/cv_soc_devkit_ghrd/software/spl_bsp/uboot-socfpga/spl/u-boot-spl] 오류 1

make[2]: 디렉터리 '/cygdrive/c/intelFPGA/18.0/embedded/examples/hardware/cv_soc_devkit_ghrd/software/spl_bsp/uboot-socfpga/spl' 나감

Makefile:611: 'spl/u-boot-spl.bin' 타겟에 대한 명령이 실패했습니다

make[1]: *** [spl/u-boot-spl.bin] 오류 2

make[1]: 디렉터리 '/cygdrive/c/intelFPGA/18.0/embedded/examples/hardware/cv_soc_devkit_ghrd/software/spl_bsp/uboot-socfpga' 나감

make: *** [uboot-socfpga/spl/u-boot-spl.bin] Error 2

----------------------------

 

How can I fix this error?

0 Kudos
5 Replies
Abe
Valued Contributor II
1,560 Views

The main issue may be due to permissions as the error describes:

 

" cannot open map file u-boot-spl.map: Permission denied"

 

Check if your working / code folders have requisite permissions - read/write before executing the make command. Also verify that you are not referencing another user's workspace which might be in read-only mode.

 

Did you run the command with super-user/root privilages (su make/ sudo make) try running it that way and check.

0 Kudos
Fawaz_Al-Jubori
Employee
1,560 Views

Hello,

Try to run SoC EDS as Administrator and see if you can overcome this issue.

 

Thanks

0 Kudos
Fawaz_Al-Jubori
Employee
1,560 Views

Hello,

Does the note above helped you Abraham?

 

Thanks

0 Kudos
ABara8
Beginner
1,560 Views

Hello, I had this problem and cheking prepissions helped me. Files, extracted by untar had only read and exec premissions, so did parent folder

Sperber
Novice
1,526 Views

Hi,

I'm facing the same issue.

I tried to change permissions of my code directory to 777

I also tried to change windows permissions for this file.

 

Can you explain in detail, what worked for you?

 

 

Thank you very much.

 

 

0 Kudos
Reply