Flash Programmer error

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

Flash Programmer error

1,010 Views

There always is a problem with my board while I use the Flash programmer download my software project into the Flash.

the problem is:

Using cable "ByteBlasterII [LPT1]", device 1, instance 0x00

Resetting and pausing target processor: OK

: Checksumming existing contents

00000000 : Reading existing contents

Checksummed/read 57kB in 2.4s

00000000 ( 0%): Erasing

Erased 128kB in 0.6s (213.3kB/s)

00000000 ( 0%): Programming

assertion "m_state == STATE_DEBUG" failed: file "nios2oci.cpp", line 237

Signal 6

But,I had download my software project into the Flash twice.

Who can help me?

Thanks.

Tenglong

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.