- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have create avalon-MM slavo part for my 1 port RAM and I use .mif file as my memory file for my 1 port RAM. When I run in Nios2 IDE software, I can read all the .mif data successfully. But, when I change the data in .mif file, and rerun again in Nios2 IDE software, I still get previous .mif data. May I know how to update my .mif data? thanks!!!Link Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Recompile the quartus project after the mif file changed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You don't need to recompile the whole Quartus project.
Simply select Update Memory Initialization File in Quartus processing menu. Cris- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
And do not forget to re-run the assembler after that.
Basically: 1. change .mif file(s) 2. select Update Memory Initialization File in Quartus processing menu 3. run the assembly step- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I am trying above two steps to update the contents of my .mif files, but output always shows results from first .mif files. any suggestions, what i might be doing wrong? Thanks,
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page