I Can not run my Nios II program, because of "Project does not have an ELF file"

[FZhan39]

Hello,friends

there is a problem when i used Nios II, "project does not have an ELF file, Please make sure project has been built successfully",

Do anyone kown this issue?

 

Thanks

[Ahmed_H_Intel1]

Hi,

What is the size for your on-chip memory that been vectored as reset memory and exception memory? if it is not an on-chip memory please let me know. It is mainly the size isn't enough or the bsp setting isn't the correct setting for the chosen memory.

Regards,

[FZhan39]

Hi,

It is on chip memory,and the size as following:

RAM on chip is 8192bytes

ROM on chip is 8192bytes

I tried to set the size of RAM and ROM is 4096bytes, but the issue is still..

[FZhan39]

[Ahmed_H_Intel1 · Accepted solution]

Hi,

8192 Bytes is small for an application, please let me know what device family you are using? I normally start with 64000 Bytes and see if the application will fit or not.

Regards,

[FZhan39]

The FPGA is Cyclone 10, I have solved the issue by increasing the RAM.

Thank you so much!

[Ahmed_H_Intel1]

You are welcome , I will consider this case is closed.