Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
Success! Subscription added.
Success! Subscription removed.
Sorry, you must verify to complete this action. Please click the verification link in your email. You may re-send via your
profile.
I want to use the IDT71V416S SRAM core form the Altera development boards with the same SRAM chip but only with a 16-bit data bus. Is it possible to do this? I have no possibility to change the width of the address bus in the properties http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/sad.gif and so I am not sure if it works when I connect only 16 bits of the data bus and two byte enable lines to my SRAM chip. Thanks for helping a newbie http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/smile.gif
