Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

Reset Signal in Hardware Tutorial

Altera_Forum
Honored Contributor II
‎05-31-2010 02:37 AM
1,077 Views

In hardware tutorial, why the reset signal is pulled to Vcc? When i run the count Binary in Nios II SBT 4 Eclipse, the count binary is never reset each time i run as hardware. 

 

Could anyone help me? 

 

Thanks, 

CARIDEE
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.