Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12661 Discussions

Resetting FPGA with NIOS processor programmed

Altera_Forum
Honored Contributor II
‎10-08-2014 06:15 PM
1,068 Views

Hello, 

 

I have a Cyclone EP3C FPGA configured with a NIOS processor and some I/O's. 

Is there somebody who can explain to me how I can reset the FPGA and the NIOS processor. 

Do I need to connect come external reset-circuity to the FPGA or to the reset_n pin which is connected to the NIOS-processor. 

 

Thank you for any responses and best regards, 

 

Wamor
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎10-27-2014 01:18 PM
398 Views

Hello, Wamor, 

 

You can connect a button to the reset_n pin of your system. This is how I usually do. Not sure, if this is what you asked about though.
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎02-02-2015 09:04 PM
398 Views

Thank you Olga for you reply. I have connected a resistor and capacitor to the reset_n pin in order to have a power-on reset. 

This work fine for my now. 

 

Regards, 

 

Wamor
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.