Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

SPI SLAVE PROGRAMMING HELP!

Altera_Forum
Honored Contributor II
‎12-23-2006 07:00 AM
1,171 Views

we have just started working on nios so the question which i am going to post may look stupid but will be great help for us if u reply soon. 

 

once i design spi slave on SOPC do i need to specify the spi logic in nios ide software like do i need to specify the instructions for spi registers the command for read and write data or these protocol directly becomes the part of system as soon as we define it. 

 

if we have to define the logic for spi slave in ide then can u suggest where we can find a working code for demonstration and can we simulate the design in quartus before downloading it on board 

 

thanks in advance 

ashish
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.