Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12698 Discussions

Simulating NiosII in Modelsim

Altera_Forum
Honored Contributor II
‎02-15-2012 11:02 PM
998 Views

Hello, 

 

I'am simulating a small Nios II System in with Modelsim. 

 

After starting the Simulator from the Eclipse, 

I use the command "s" in Modelsim to compile all HDL source code and to load the design. 

I use the command "w" to open the Wave window with "useful" signals. 

 

Now i can run my Design. 

 

My Question: 

What should i do to see the "OpCode" and the Nios Pipeline structure in Modelsim, like in the attached File ? 

 

Thanks,  

Nicolas
opcode.JPG
(Virus scan in progress ...)
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.