Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

arria 10 jtag problem while using ds5

Altera_Forum
Honored Contributor II
1,914 Views

hi all, 

I canot connect to my arria10 board when using ds5 to debug hps,but in quartus16.1 programmer tool i can see the hps device. 

which the differences between the ds5 and the quartus about thire jtag connection things? 

does someone take any problems like this? 

 

best wishes, 

hl
0 Kudos
3 Replies
Altera_Forum
Honored Contributor II
748 Views

When you say you can't connect, what exactly is happening? Do you have a license for DS-5? Licensing is required for running code over JTAG.

0 Kudos
Altera_Forum
Honored Contributor II
748 Views

Hello, 

 

I am getting the same problem as mentioned above is any solution for it?? 

 

Thanks 

 

Krunal Gandhi
0 Kudos
Altera_Forum
Honored Contributor II
748 Views

Here, I like to mentioned that I use Cyclone V SoC custom design board with the reference of Cyclone V SoC development board.

0 Kudos
Reply