epcs programmed,little code ok, large code have problemes

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

epcs programmed,little code ok, large code have problemes

987 Views

Quartus 11.1, Cyclone IV 55E, design

My design includes a 1.8V Mobile DDR (which seems to be working fine), a Serial Flash,Micron 256Mbit, UART.

NIOS reset vector: epcs Controller ,

exception vector: DDR controller,

the whole project be working fine with jatg.

SOF and ELF file create JIC file, serial flash program OK.

Reboot,power up, FPGA configuration be fine.

But elf code once in a while be running OK, many times not running.

After simplification of Project code ,including 'mem' ,'printf',pointer variable instruction, etc., cause of obvious hindering EPCS running, and many available codes, NIOS be running fine.

If project have any 'mem' ,'printf',pointer variable instruction, 'write_flash', 'read_flash',open Uart file, etc., the elf code does not work!

Any suggestions?

Thanks a lot,

Aaron

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.