Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

problem when i program my FPGA

Altera_Forum
Honored Contributor II
‎07-23-2005 10:31 AM
1,388 Views

When i program my FPGA,system told me: 

 

Info: Started Programmer operation at Sat Jul 23 18:27:21 2005 

Error: Can't configure device. Expected JTAG ID code 0x020010DD for device 1, but found JTAG ID code 0x020050DD. 

Error: Operation failed 

Info: Ended Programmer operation at Sat Jul 23 18:27:22 2005 

I don't know what caused it and how to solve it?  

thx
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎07-23-2005 05:30 PM
466 Views

It's a device mismatch error. Check to make sure that the device you've defined (in Quartus II) matches the actual FPGA on your board. 

 

- slacker
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.