Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

problems with debug

Altera_Forum
Honored Contributor II
‎03-27-2006 07:40 AM
991 Views

hi everyone! i use the niosII_cyclone_1c12_eval board! 

i met several problems.when i debug the program,it shows"nios2-terminal: connected to hardware target using JTAG UART on cable 

nios2-terminal: "Nios II Evaluation Board [USB-0]", device 1, instance 0 

nios2-terminal: (Use the IDE stop button or Ctrl-C to terminate)" 

in the console! 

i don't know what's wrong with my problem , 

the other question is when i printf("hello world\n") in myprogram (i have add a jtag_uart in my sopc) it runs correctly! 

the only problem is in the console,the "hello world" doesnot appear! 

could anyone help!
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.