- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I write a interface for a DDS,but at last i find that i must do "run as hardware"two times,if i want to send some data to frequencywords of DDS.whatever have i writen in the program ,i doesn't work. i can't find where's the problem. if i can write it in,why i must do "run as hardware" two times?
only this way the user logic "DDS" get "writedata" from avalon bus.why? thank you in advance.Link Copied
5 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i accurately follow the avalon times,why it doesn't work.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
if you do "run" in the nios ide software,what will the software do ,and what will the hardware do ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i still haven't resolved it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
even i am not so clear about this also if u "run" with the three debug options 1) downlaod into RAM 2) attach 3) reset and then run from it.... what does hardware and software do individually??? can anybody explain it in detail? moreover it is no where clearly given in any of the documents of NIOS IDE thanks and regards prasad- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you .
at last i change a board ,i got it ,but i didn't change anything. are there any problems with the board or the softcore of atlra. does anyone barges up against these problems?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page