Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

why the NiosII program don't run in 13.1

Altera_Forum
Honored Contributor II
‎12-06-2013 05:29 AM
1,243 Views

when i use NiosII 13.1 , the program don't run when i checked the "reset the selected system" in "run config" tab.the same problem, when I programmed the sof and elf to the epcs with "NiosII flash programmer", the program will not run when power on,but the logic is running. 

who can tell me why? 

the same project is ok in 12.1.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎01-21-2014 09:23 PM
523 Views

Unfortunately I run exactly into the same issue. Did you found a solution for that?

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.