Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

An advice is needed

Altera_Forum
Honored Contributor II
1,111 Views

Hi, 

I intend to make an OFDM demodulator & MPEG4 decoder in a single chip for a diploma project. Can you refer me which FPGA maybe suitable for a such project (the point is to be not very expensive). 

Thanks
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
437 Views

I have no clue how big MPEG4 decoding will be in an FPGA but I seem to recall OFDM wasn't too large. I'll take a stab in the dark and say maybe a Cyclone III 120 device would be large enough but I would wait for others with MPEG4 experience to chime in. Another factor is what interface do you plan on using the move the data in and out of the FPGA and what kind of throughput are you looking for? The higher end FPGAs will have more capabilities as you know so if you are doing something bleeding edge you may need Arria or Stratix. 

 

Here is a Cyclone III board with a 120 kLE device on it to give you an idea of the pricing: http://www.altera.com/products/devkits/altera/kit-cyc3.html
0 Kudos
Reply