Another Cyclone III problem

[Altera_Forum]

Hi, 

I've got a problem with configuring CycloneIII(EP3C120F780I7N) in AS mode on my custom board. Also when I   try to programm my EPCS64, Quartus programmer says that Device ID can't be read. Another thing is that after   I turn the power on I see strange AS signals from FPGA (Bank 1 is powered with 2.5V but nCSO=2.5V,   DCLK=2.5V, ASDO=2V, DATA0=2V). So it means that FPGA doesn't even try to configure itself. Programming EPCS with .jic file also fails.  But if I try to configure FPGA via JTAG, everything works well.  I've already tried changing EPCS and even FPGA and it didn't help. Any helpful suggestions?

[Altera_Forum]

Maybe the capacitance on your AS lines is too big. You should check values of your capacitors

[Altera_Forum]

That's it! The problem solved)) 

There were 87nF capacitors instead of 10pF. Company where my custom board was made failed.  Thanx))