Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Arria 10 FPGA with urjtag

Altera_Forum
Honored Contributor II
‎03-14-2018 05:19 PM
1,841 Views

I design a board with altera Arria 10 FPGA "10AX115N3F40I2SG" i can successfully program Fpga with altera bus blaster 2. Now I want to program board by using bus blaster V3, i tried a lot but failed to program it. Urjtag can not recognize the bsdl file. I download the bsdl file from altera website. I wonder did i downloaded correct file, the file i downloaded was "10AX115NF40". Any help can be appreciated to pull me out from this problem thanks. I attached the urjtag command line image as well.

Preview file
98 KB
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.