- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We use a 256-FBGA Altera device on our product, which is in turn a surface-mount device. Should there be any requirement to bake our parts prior to our customer's reflow (is there any risk of moisture absorbtion by the BGA package once it has been mounted to our board)?
:confused:Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The requirements are printed on the packing bags, if I remember right. Most Altera devices have one week floor lifetime (unpacking until needing baking). Moisture absorption of the mounted devices can be an issue, if board rework is required. Then the baking procedure applies to the board, I think.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page