Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
Need Forum Guidance? Click here

Search our FPGA Knowledge Articles here.
18988 Discussions

Burst transfer from Avalon MM Master BFM

Altera_Forum
Honored Contributor II
829 Views

Hello,  

I am using an Avalon MM master BFM and connecting it to DDR4. I am able to perform single write and single read operation successfully. When I try to do the burst operation, I am unable to see burst of data being transferred. The burst size and burst count signals of Avaon BFM are being varied for this but I don't see any change in transfer type. 

 

Is there any specific configuration to be done for controlling burst mode transfer?  

Also for each data,which is part of the burst transfer should I give address individually or will my BFM perform the address increment operation automatically(enabled the begin burst transfer checkbox so expecting it to perform on its own)? 

 

Thank You.
0 Kudos
0 Replies
Reply