Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

Can't recognize silicon id problem on cyclone III

Altera_Forum
Honored Contributor II
‎09-30-2013 04:46 AM
910 Views

Hi, guys 

This problem really makes me crazy, I have seen similar problems posted but no solution. 

I am currently using the Cyclone III Starter Kit. 

I wanted to program the configuration flash device to replace default configuration on power up. 

Following the directions on User Guide, "Appendix A. Programming the Configuration Flash Device" 

I converted .sof file to .pof file and choose CFI_128M flash.  

However, every time I program the project, the programmer gives an error: 

can't recognize silicon id for device 1 

 

I am using JTAG mode, tried using both built-in USB-Blaster and external USB blaster, but the error both occurred. 

Using JTAG mode, it is successful to program the sof file to RAM and run correctly. So the JTAG is OK. 

And I am pretty sure choosing the right device in project. 

 

I have found the official explaination from altera for the problem, but not helpful for my case. 

http://quartushelp.altera.com/12.0/mergedprojects/msgs/msgs/epgme_device_siid_error.htm 

 

I'd appreciate any help or advice, thanks !
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.