- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have two cyclone I devices on my board I have kept a provision to configure them in active serial mode. I am using one epcs4 configuration device for each fpga. right now i am using separate jtag connectors for both the fpgas, Is there any way in which i can configure both the fpgas using the same jtag connection? thanks in advanceLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, put them in a JTAG chain (connect TCK and TMS in parallel, chain TDO to TDI)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page