- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello everybody
I'am a beginner at the VHDL programming. I use CPLD Max V (5M570ZF256C5N) in my internship and I have to write a program in VHDL. the program is selection between two audio sources via I2S bus. so I do not know how to write the I2S protocol on quartus can you help me to solve this problem. thank you.Link Copied
9 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
1. Collect information about HDL (VHDL, Verilog) languages & I2S protocol like IEEE Papers, Case study, Thesis etc. 2. Study & understand the protocol. 3. Start HDL coding parallel & also go through the Intel online training for HDL & Quartus tool. Refer the following links & attachment, https://www.altera.com/support/training/curricula.html Best Regards Vikas Jathar (This message was posted on behalf of Intel Corporation)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you Mr vikas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello vikas
i have read the PDF tha you give me and i searched on the internet. I found the I2S_interface VHDL program. i tried to compile it but I had some error. after resolve the maximum possible of error I still have some of them. here is the message that says there is an error: here is the code :- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
generic ( DATA_WIDTH : integer range 16 to 32;
BITPERFRAME : integer );
Modify the code like bellow,
generic ( DATA_WIDTH : integer := 32;
BITPERFRAME : integer := 0
);
If want to use in the range format then use a signal like a bellow,
signal temp : integer range 0 to DATA_WIDTH := 0;
Let me know if this has helped resolve the issue you are facing or if you need any further assistance. Best Regards Vikas Jathar (This message was posted on behalf of Intel Corporation)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The screenshot is not visible properly. Have you provided all input stimulus in Testbench? If not then refer testbench format from Google & check again. Please open a new thread for better support. Best Regards Vikas Jathar (This message was posted on behalf of Intel Corporation)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page