Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20693 Discussions

Cyclone 10 GX: unused GX Transceiver

MGerm5
Beginner
‎05-29-2019 03:04 PM
749 Views

1)Can I connect VCCR_GXBL, VCCT_GXBL, VCCL_GXBL to GND if none of the Transceivers is used?

2) Can I connect VCCH_GXBL to GND?

0 Kudos

Link Copied

1 Reply
Deshi_Intel
Moderator
‎05-30-2019 03:22 AM
407 Views
hi, In general, you can refer to Cyclone 10 pin connection guideline for power connection usage guideline. https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/dp/cyclone-10/pcg-01022.pdf Based on Cyclone 10 pin connection guideline (page 17), it's still recommended to power up VCCR and VCCH, the only exception is VCCT. Thanks. Regards, dlim
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.