- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Sir,
I have designed the board with EP3C120F484 cyclone III. In this board i have used EPCS128 Flash. I am using AS Configuration. But when i started the configuration. The configuration get failed at once. Please provide the remedy for this fault.Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
try checking this doc and see if there is any issue you can detect on your board:
https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/an/an523.pdf- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What are the configuration modes you have?
Do you have JTAG? Did you try program the SOF file through the JTAG? If SOF programming is working, this means the JTAG is working. You may then try the JIC file programming. What is the error message you see?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page