Cyclone III / IV with ADSP21469 DSP

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

Cyclone III / IV with ADSP21469 DSP

1,283 Views

Hello,

i would like to connect the Cyclone and the DSP on the same lines (Data bus , Address Bus , Rd , Wr , etc ) to the same Flash ( both the Cyclone firmware and the DSP software will be in the Flash ) , my questuion is - can i do it straught forward or i have to do something special at the connections between them , it is important to know that the FPGA is configured first and only after that it turns on the DSP power supply .

Thanks

Dotan

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.