Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Cyclone III and FLash --need some help people

Altera_Forum
Honored Contributor II
‎11-19-2007 07:53 PM
1,224 Views

Dear Fellow Users 

 

I need some help programing my FLash on my cyclone 3 development board. I am using a 1 MHZ clock, so timming should not be an issue. Please could you have a look at the attached pdf image as it shows my state machine. i am have no luck, it would be nice if some one could show where i am going wrong. 

 

Regards 

 

Dharmesh
Preview file
57 KB
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.