Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Cyclone III expansion prototype connectors

Altera_Forum
Honored Contributor II
‎03-19-2008 10:17 PM
1,065 Views

Hi, 

I am using cyclone iii EP3C25F324C8. I am trying to connect uart using the expansion prototype connectors. But it is not working. 

I have avoided using clock pins. Is there a special pin that i have to use for rxd and txd, or i can use any pins on the expansion connector.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎03-20-2008 07:35 AM
380 Views

You can use any pin with suitable IC voltage. In some cases pin placement rules could be violated, but Quartus fitter will tell you then. You can also check in compilation report pin-out list, that the pins actually have been placed where you wanted them.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.