Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21611 Discussions

Cyclone IV GX Transceiver failed to upload program

Altera_Forum
Honored Contributor II
‎04-09-2011 07:57 PM
1,098 Views

Hi everyone, 

 

I got the error when trying to upload a program to FPGA: 

Error: Can't configure device. Expected JTAG ID code 0x028010DD for device 2, but found JTAG ID code 0x020A40DD.  

Can anyone help me resolve this issue? 

 

By the way, I am a little confused to identify the chip of the FPGA in Quartus II. From the manual attached with the board, it says that the chip is EP4CGX15BF14. From what I saw the chip on the board, it is EP4CGX15BF14C8N. And from the Device List in Quartus II, there are some similar devices to choose:  

 

EP4CGX15BF14C6 

EP4CGX15BF14C7 

EP4CGX15BF14C8 

EP4CGX15BF14I7 

 

:confused:
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.