Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Cyclone IV Jrunner configuration fails with Remote-Update image

Altera_Forum
Honored Contributor II
‎12-15-2016 04:13 PM
1,073 Views

I am trying to do an initial program-load of a Cyclone IV using JRunner. There is an attached EPCS64 that has NOT been programmed. 

 

I can successfully use Jrunner to program an image that does not contain remote update. 

 

When I use Jrunner to load an image containing remote update, the CONFIG_DONE pin goes high for 12mS then goes back low. 

 

If I load the non-remote-update image first and then the remote-update image, the load is successful. 

 

Any ideas? I really don't want to load two images!!!
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.