- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can we set some selected FPGA pins default value to some defined state(1,0 or high impedance) during configuration cycle? Regards, SanjuLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"During configuration" means before the configuration has been loaded and executed. Respectively the configuration file can't set the state of any IO pin in this phase. The state during configuration is determined by the FPGA hardware. If it has no features to set the IO state specifically, you get the fixed default behavior only.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page