Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

Design Kit for Stratix III DSP Development Kit to interface with TI cards

Altera_Forum
Honored Contributor II
1,314 Views

Hi all, 

I've recently purchased an Altera Stratix III DSP Development Kit for use in my company. I've purchased a DAC3484EVM for D/A and a ADS5474EVM for A/D. I was hoping to interface the Altera board with the D/A and A/D, but I can't receive or get out signals from either board. I realized it's because I need to "download" a design kit that can allow the board to interface with both cards. The board comes with an add-on card with A/D and D/A inputs/outputs along with a design kit to download to the FPGA. When I downloaded the design kit, attached the card, and ran the D/A output to the A/D input, I saw that I could get waveform in the A/D input. Does anyone have a design kit that will allow me to interface the Altera board with these two specific cards? 

 

Thanks, 

 

Daniel
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
524 Views

I forgot to mention that both cards are both from TI. These cards were designed to interface with an Altera/FPGA board. So I think there should be a design kit that will allow them to be interfaced with.

0 Kudos
Reply