- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a question about the part markings. On the second line of the part markings the first (bottom left) letter is an "S". I am being told by my engineer that the second line should always start with a "9". Does anyone have any documentation as to what the "S" is? Thank you for your time.
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have a look at this Document
http://www.altera.com/literature/pcn/pcn0514.pdf?gsa_pos=1&wt.oss_r=1&wt.oss=epcs part marking (http://www.altera.com/literature/pcn/pcn0514.pdf?gsa_pos=1&wt.oss_r=1&wt.oss=epcs part marking) or maybe better http://www.altera.com/literature/pcn/pcn0801.pdf?gsa_pos=2&wt.oss_r=1&wt.oss=epcs16si8n pcn (http://www.altera.com/literature/pcn/pcn0801.pdf?gsa_pos=2&wt.oss_r=1&wt.oss=epcs16si8n pcn) But they only identify assembly site “9” = Malaysia “B” = Amkor Philippines “Z” = Morocco but no "S"
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page